Compare

Technical Specifications

Table size 10” x 54” (250 x 1370mm)
T slot of spindle ( Qty X ) 3 x 0.629″ (3 X 16 mm)
Longitudinal travel ( W/O Power Feed ) 34″(870mm)
( with Power Feed) 30.5″ (775 mm)
Cross travel 16” (410mm)
Travel of knee 17” (450mm)
Quill travel 5” (127mm)
Spindle to table nose (D) 3.3”- 21” (85-535mm)
SPINDLE
Spindle taper NST#40
Spindle speed (RPM) – Variable speed head
50 Hz LOW : 50 ~ 415 HIGH : 415 – 3600
60 Hz LOW : 60 ~ 500 HIGH : 500 ~ 4300
Quill travel 5” (127 mm)
Ram travel 22” (560 mm)
Over swivel on turret 360º
Quill feeds (mm/rpm) 0.0015″ ~ 0. 003″ ~ 0.006″
Head swivel (R & L) #ERROR!
Head tilt (up & down) Option
Spindle to column (E) 7”-29” (178-738mm)
MOTOR
Spindle motor 5 HP
MACHINE SIZE
Overall height 93 1/2” (2375mm)
Overall depth 83 1/2” (2120mm)
Overall width 72.4” (1840mm)
Net weight 3500 lbs. (1600 Kgs)
  • NOTE: We reserve the right to modify and improve the specification without notice, the specification shown above is for reference only.

Features

10″ × 54″ Table , long saddle & box way on Y
Hardened & Ground Table with Ground T-Slot
5HP Spindle Motor, Hi-Lo speed change by gear transmission (without no timing belt)
NST#40 Spindle Material Scm415(SAE4115)Hardened & Ground.
Bearing support to the motor shaft
Unique rigid design on spindle auto-feed, spline design on the pinion & clutch support
Turcite-B On X&Y Ways, Slideways and Gibs.
Hardened & Ground X&Y Slideways.
Electroless Nickel-Phosphorus Process On X&Y leadscrew with hardness 35 HRC.
Leadscrew nut made from PBC2, phosphor bronze
Highly Improved Vari-Speed Head
Lifting motors installed
Electrical Box and control Panel
1-1/2”(38mm) Diameter Lifting Screw.
Leveling Screw & Plate On Base.
Rubber chip cover (front & rear )
Tool box & Tools
Machine made in Taiwan complete

Reviews

There are no reviews yet.

Be the first to review “SP-520VS”

Your email address will not be published. Required fields are marked *

Back to Top